50CC STICK ARF AIRPLANE (NEW FOR 2013) YOU ASK FOR A BIG STICK? HERE IT IS!!!

tem No: CY8030E

NOTICE: DUE TO THE VERY LARGE BOX SIZE (67X24X13) PRICE AND SHIPPING DOES INCLUDE THE OVERSIZE AND SURCHARGE PRICES. Sorry for the shipping price. Shippers charge for volume.

2 peice wing joined with a large alum wing tube. Slide the wing over the wing tube and attach them together with 2 bolts. After wing is together it attaches to the fuselage with the hook that is made into the leading edge and the 2 wooden dowels. Then the rear of the wing bolts into the fuselage. Remember that these are stress points and care should be taken to make sure that its strong enough for your type of flying. Its very strong from the factory but it never hurts to double check and beef it up.

Wing Cord is 21 1/2"

15" by 4 1/2" flaps and 23 by 4 1/2" ailerons

Fuse is 6" by 6" square. Motor box is 5 1/2" by 5 1/2" and constructed with lite-ply. Lighting holes are cut into fuselage to reduce weight but still maintain strenght.

Aileron and flap servos mount inside the wings and only the servo arms extend through the servo doors to give a cleaner design. Flap and ailerons are conected to the servos with short push rods (supplyed)

Rudder is a pull pull system and only requires a single servo, but 2 slots are provided if you want to double up the servos.

The horizonal stab. bolts to the fuselage and is 36" wide including the elevators. The elevator halves are conected to the 2 elevator servos that mount in the rear exterior of the fuselage and conects with short push rods.

Landing comes with your choice of tail dragger or tricycle gear and both are included in this ARF. The nose gear (if you use) is double spring loaded wire system conecting to a single heavy alum. strut, then to the motor box. The main gear is 2 peice alum. and has a brace wire about half way down each side conecting the 2 halfs together for additional support.

Plane has a top front hatch that is 3 1/2" wide and 8 1/2" long and opens with a spring loaded thumb latch.

Comes with hardware kit including 4" rubber tires (not foam) Fuel tank, push rods and conectors, hindges etc. but does not include a spinner. Engine and electronic equipment are not included.

Plane weighs 14 lbs. including all supplyed hardware but not your engine and radio gear.

Wingspan: 2360 mm (93 in)

Wingarea: 123.6 dm2 (1916 sq.in)

Length: 1950 mm (76.7 in)

Engine: 35-50 gas engine

Radio: 6 Channles;8 Servos

Empty weight: 5 kg

Take off weight: kg